Install the CMOD Cover
4.
Lift the CMOD top cover away from the CMOD.
Install the CMOD Cover
When removing or installing the CMOD cover, always maintain component serviceability
requirements with regard to static protection.
1.
"Remove a CMOD" on page
2.
To install the cover, position it over the CMOD chassis with the green button at
the front.
Set the cover on the chassis, leaving a gap of approximately 1 inch (25 mm)
3.
between the lead edge of the cover and the front of the CMOD.
Ensure that the edges of the cover encapsulate the edges of the chassis, and
4.
that the pins in the cover are aligned with the slots in the chassis sidewall.
166
Oracle Server X7-8 Service Manual • October 2017
162.