Connect Ilom To The Oracle X8-2; Install The Software On The X8-2 - Oracle Netra Server X5-2 Installation Manual

Lead the cables neatly away from the rear panel.
4.
Plug in the cables to their respective destination components.
5.

Connect ILOM to the Oracle X8-2

Use the following procedure to make a connection to the Oracle X8-2 Oracle
Integrated Lights Out Manager (ILOM) port. For a remote permanent connection to the
Service Processor over the ILOM connection, use the rear panel NET MGT port.
Note:
Keep Ethernet cables separated from power cables by at least 60mm where
possible and never run them in the same channel of the rack without
segregation.
•
Locate the cable to connect to the Oracle X8-2 for Communications.
1.
Plug the RJ-45 connector into the ILOM port.
2.
Figure 4-15
Lead the cable neatly away from the rear panel.
3.
Connect the other end of the cable to the LAN.
4.
• Refer to the Oracle X8-2 hardware documentation
E93359_01/html/E93391/index.html) for information about how to configure the
Web browser application to connect to the console, and how to establish
communications with the Oracle X8-2.

Install the Software on the X8-2

The Oracle Communications Session Router (OCSR) requires software installation
when deployed on the Oracle X8-2.
Software installation to Oracle X8-2 includes the following high-level steps:
Insert your installation media into the USB slot or connect the ISO image by way of
1.
Oracle Integrated Lights Out Manager (ILOM) virtual media.
Power on the Oracle X8-2.
2.
Observe the startup process, and press F8 to enter the boot menu when it
3.
becomes available.
Select the bootable USB or ISO setting.
4.
Category 6 (or better) Ethernet
Connecting to ILOM over the Network
Connect ILOM to the Oracle X8-2
NET MGT
(ILOM)
(https://docs.oracle.com/cd/
Chapter 4
4-12