Region (Mstp) - Centrecom FS980M/9 Command Reference Manual

S T C
PANNING REE OMMANDS
(MSTP)
REGION

region (MSTP)

Overview Use this command to assign a name to the device's MST Region. MST Instances
(MSTI) of a region form different spanning trees for different VLANs.
Use this command for MSTP only.
Use the no variant of this command to remove this region name and reset it to the
default.
region <region-name>
Syntax
no region
Default By default, the region name is My Name.
Mode MST Configuration
Usage The region name, the revision number, and the digest of the VLAN to MSTI
configuration table must be the same on all devices that are intended to be in the
same MST region.
awplus#
Example
awplus(config)#
awplus(config-mst)#
Related revision (MSTP)
Commands
show spanning-tree mst config
613-50137-01 Rev A
Parameter Description
<region-name> Specify the name of the region, up to 32 characters. Valid
characters are upper-case, lower-case, digits, underscore.
configure terminal
spanning-tree mst configuration
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
region ATL
455