Switchport Access Vlan - Centrecom FS980M/9 Command Reference Manual

VLAN C
OMMANDS

SWITCHPORT ACCESS VLAN

switchport access vlan
Overview Use this command to change the port-based VLAN of the current port.
Use the no variant of this command to change the port-based VLAN of this port to
the default VLAN, vlan1.
Syntax switchport access vlan <vlan-id>
no switchport access vlan
Default Reset the default VLAN 1 to specified switchports using the negated form of this
command.
Mode Interface Configuration
Usage Any untagged frame received on this port will be associated with the specified
VLAN.
Examples To change the port-based VLAN to VLAN 3 for port1.0.2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To reset the port-based VLAN to the default VLAN 1 for port1.0.2, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show interface switchport
Commands
show vlan
613-50137-01 Rev A
Parameter Description
<vlan-id>
<1-4094> The port-based VLAN ID for the port.
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
switchport access vlan 3
no switchport access vlan
414