Cwmp Cpe Inform Interval - HPE FlexFabric 5930 Series Network Management And Monitoring Command Reference

Views
CWMP view
Predefined user roles
network-admin
Parameters
times: Specifies the maximum number of CWMP connection retries. The value range is 0 to 100. To
disable the CPE to retry a CWMP connection, set this argument to 0.
Usage guidelines
The CPE retries connecting to the ACS when its initial connection attempt fails or the CWMP session
is ended before the CPE receives a session closed message from the ACS. The CPE stops its
connection retry attempts until the connection is established or the number of connection retries
reaches the upper limit.
Examples
# Set the maximum number of CWMP connection retries to 5.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe connect retry 5

cwmp cpe inform interval

Use cwmp cpe inform interval to configure the periodic Inform interval.
Use undo cwmp cpe inform interval to restore the default.
Syntax
cwmp cpe inform interval seconds
undo cwmp cpe inform interval
Default
The periodic Inform interval is 600 seconds.
Views
CWMP view
Predefined user roles
network-admin
Parameters
seconds: Sets the periodic Inform interval in the range of 10 to 86400 seconds.
Usage guidelines
This command sets the interval for the CPE to send Inform messages automatically to the ACS. For
the command to take effect, you must configure the cwmp cpe inform interval enable command.
Examples
# Set the periodic Inform interval to 3600 seconds.
<Sysname> system-view
[Sysname] cwmp
[Sysname-cwmp] cwmp cpe inform interval enable
[Sysname-cwmp] cwmp cpe inform interval 3600
332