Display Logbuffer - HPE FlexNetwork 7500 Series Network Management And Monitoring Command Reference

Information timestamp format:
Loghost: Date
Other output destination: Date

display logbuffer

Use display logbuffer to display the state of the log buffer and the log information in the log buffer.
Syntax
In standalone mode:
display logbuffer [ reverse ] [ level severity | size buffersize | slot slot-number ] *
In IRF mode:
display logbuffer [ reverse ] [ level severity | size buffersize | chassis chassis-number slot
slot-number ] *
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
reverse: Displays log entries chronologically, with the most recent entry at the top. If you do not
specify this keyword, the command displays log entries chronologically, with the oldest entry at the
top.
level severity: Specifies a severity level in the range of 0 to 7. If you do not specify this keyword, the
command displays log information for all levels.
Table 82 Log levels
Severity
value
0
1
2
3
4
5
6
Level Description
The system is unusable. For example, the system
Emergency
authorization has expired.
Action must be taken immediately. For example, traffic
Alert
on an interface exceeds the upper limit.
Critical condition. For example, the device temperature
Critical exceeds the upper limit, the power module fails, or the
fan tray fails.
Error condition. For example, the link state changes or a
Error
storage card is unplugged.
Warning condition. For example, an interface is
Warning
disconnected, or the memory resources are used up.
Normal but significant condition. For example, a terminal
Notification
logs in to the device, or the device reboots.
Informational message. For example, a command or a
Informational
ping operation is executed.
361
Corresponding
keyword in
commands
emergency
alert
critical
error
warning
notification
informational