a) The way in which the afterimage disappears is affected by both the Decay and KF Strobe
Dust parameter adjustments for the keyframe strobe.
Disabling the keyframe strobe afterimage
Press [KF Strobe Disable], turning it on.
If you turn this function on when creating a keyframe, even as the effect passes
a keyframe, no afterimage remains.
Setting a combine process
Select whether to add the Keyframe Strobe effect before or after the combine.
Notes
• The combine process function is not supported on the MVE-8000A.
• When you change the selection in the <Combine Process> group, the
afterimages which had been added up to then disappear.
• When you do not combine images, the Keyframe Strobe effect only is
applied, regardless of the selection in the <Combine Process> group.
Select one of the following in the <Combine Process> group.
Combine –> KF STRB: Add the Keyframe Strobe effect after the combine.
As parameters, the data for the channel with the lowest number among the
channels being combined is enabled.
KF STRB –> Combine: Add the Keyframe Strobe effect before the combine.
Parameters can be set independently for each channel.
Wind Settings
Notes
• The wind function is not supported on the MVE-8000A.
• When wind is turned on, any of the following effects that are on are turned
off.
– Trail
– Motion decay
– Keyframe strobe
Applying the wind effect
1
In the DME menu, select VF5 'Light/Trail' and HF5 'Wind.'
The Wind menu appears.
DME Special Effect Operations
685