Sony MVS-8000X User Manual page 915

4
Press the [MOD] button in the keyframe control block.
Modifying a particular range of events
1
Carry out steps 1 to 3 of the procedure in "Modifying a single event" (the
previous item).
2
Press the [FROM TO] button in the keyframe control block, turning it on.
The numeric display in the numeric keypad control block shows the
current event number and the indication "TO."
3
To set the start of the range to other than the current event number, press
the [CLR/AUTO TRANS] button in the numeric keypad control block,
then enter the desired event number with the numeric keypad and press the
[ENTER] button. (This operation is not required when using the current
event number.)
4
Enter the event number for the end of the range and press the [ENTER]
button.
5
Press the [MOD] button in the keyframe control block.
This modifies the specified range of events simultaneously.
Modifying all events at the same time
1
Carry out steps 1 to 3 of the procedure in "Modifying a single event" (page
914).
2
Press the [ALL] button in the keyframe control block, turning it on.
3
Press the [MOD] button.
This modifies all events in the specified range simultaneously.
Deleting an event
1
Specify the edit point. (See page 913.)
2
To delete multiple events simultaneously, carry out either of the following
operations. (This operation is not required to delete the event at the edit
point only.)
Macro Operations in the Numeric Keypad Control Block and the Keyframe Control Block
915