Assigning Preview Output To Preview Selection Buttons - Sony MVS-8000X User Manual

7

Assigning Preview Output to Preview Selection Buttons

It is possible to assign any preview output to a preview selection button.
This applies to the preview selection buttons in the fade-to-black control block
and the downstream key/fade-to-black control block.
For details of these control blocks, see Chapter 2 (Volume 1).
1
2
3
4
5
To cancel an assignment
Select the button, then press [Clear].
This leaves nothing assigned.
1102
Overall Control Panel Settings (Config Menu)
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter
1 Button Assign
When you have completed the required assignments, press [Set].
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
Press [Fade To Black Module].
The Fade To Black Module menu appears.
On the left of the status area, preview selection buttons (1 to 11) appear.
On the right side a list of signals to be assigned appears.
In the button indications on the left, press the button for the assignment.
Using any of the following methods, select the signal to be assigned.
• Press directly on the list on the right.
• In the list on the right, press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
Knob Parameter
1 Button
Press [Set].
This assigns the signal selected in the list to the button.
Adjustment
Select function to be
assigned to button
Adjustment
Button selection
Setting values
1 to maximum value
Setting values
1 and upwards