Border Settings - Sony MVS-8000X User Manual

Border Settings

Adding a border
1
In the DME menu, select VF1 'Edge' and HF1 'Border/Crop.'
The Border/Crop menu appears.
2
Press [Border], turning it on.
The Border effect is enabled. You can adjust the border width parameters
with the knobs.
3
Set the parameters.
The valid ranges of the parameter values depend on the combination of
signal format (SD/HD) and aspect ratio (4:3/16:9) selected in the system,
as follows.
• 4:3 mode
Knob
1
2
3
5
Knob
1
2
3
4
5
Parameter group [1/2]
Parameter Adjustment
H Border width on left and right
sides
V Border width on top and bottom
sides
All Border width on all sides
Density Border density
Parameter group [2/2]
Parameter Adjustment
Top Border width on top side
Left Border width on left side
Right Border width on right side
Bottom Border width on bottom side
Density Border density
Setting values
Left value shown
Top value shown
Left value shown
0.00 to 100.00
Setting values
–6.00 to +6.00 (SD)
–18.00 to +18.00 (HD)
–8.00 to +8.00 (SD)
–24.00 to +24.00 (HD)
–8.00 to +8.00 (SD)
–24.00 to +24.00 (HD)
–6.00 to +6.00 (SD)
–18.00 to +18.00 (HD)
0.00 to 100.00
DME Special Effect Operations
593