Signal Output Settings (Output Menu) - Sony MVS-8000X User Manual

Signal Output Settings (Output Menu)

For setup relating to signal outputs, use the Switcher >Output menu.
To display the Output menu
In the Engineering Setup menu, select VF3 'Switcher' and HF3 'Output.'
The status area shows the output signal numbers and names, and output signal
phase for the signals output from Output 1 to 48.
The following functions are available here.
Notes
For a format converter dedicated output, Video Clip, V Blank, Through, Safe
Title, and 4:3 Crop settings are not possible.
• Output Assign: Assign the signals output from the Output1 to 48 ports.
• Video Clip: Adjust the clip levels (White Clip, Dark Clip, and Chroma Clip)
for the output signals from each of the Output1 to 48 ports.
• V Blank: Adjust the vertical blanking width for the output signals from each
of the Output1 to 48 ports. The setting is the number of scan lines from the
reference blanking position of field 1 for the particular format which should
be masked.
• Through: Enable or disable through mode. Through mode can be enabled
for AUX1 to 48 outputs, M/E and PGM/PST program outputs, and clean
output.
• Safe Title: Enable or disable safe title, and carry out settings for box 1 and
2, cross and grid.
• 4:3 Crop: Set the actual video image to be cropped to a 4:3 aspect ratio when
an HD system has a screen aspect ratio of 4:3.
• FC Adjust: Set the format converter outputs.
Assigning Output Signals
To assign a signal to output from an output port, use the following procedure.
1
In the Switcher >Output menu, press [Output Assign].
The Output Assign menu appears.
The status area shows the output ports and assigned signals on the left, and
a list of signals that can be assigned on the right.
Signal Output Settings (Output Menu)
1183