Table of Contents
Advertisement
Operations
The unit's settings can be configured remotely via the
network or manually via the unit's DIP switches.
Remote settings configuration requires a server
computer connected to the network and the Network
System Manager software (not supplied). For details,
refer to the instructions for use for the Network System
Manager software.
This section describes manual settings configuration via
the unit's DIP switches.
For details on manual configuration on the NU-IP40S,
refer to the instructions for use for the NU-IP40S.
Manual Configuration
Before operating the unit, configure settings according
to the connection environment.
If changes are made to the connection environment,
reconfigure settings according to the new environment.
Configuration flow
Sender side
(connected to video
output device)
Removing the DIP Switch Cover
Operation Mode Settings
System Frequency
Settings
Input Video Selection
Input Video Upconvert
Settings
Receiver side
(connected to
monitor)
Output Video Format
Settings
Output Video 3G-SDI
Level B Support
Settings
Output Video Color
Space Settings
Output Video
Downconvert Settings
Network Settings
Video transmission groups
Receiver IP address
Compression Mode Settings
Network Redundancy Settings
Attaching the DIP Switch Cover
Notes
Disconnect the DC power cable before configuring
DIP switch manual settings.
Changes to DIP switch manual settings will be applied
the next time the unit turns on.
Removing the DIP Switch Cover
Loosen the screw securing the DIP switch cover at the
rear of the unit, and remove the DIP switch cover.
DIP switches 1 to 3 will be revealed.
DVI
Operation Mode Settings
Configure this according to the unit's operation mode.
Operation mode
Receiver side (connected to
monitor)
Sender side (connected to video
output device)
18
Screw
DIP switches
DIP switch 1 DIP switch 2
[1]
[1]
OFF
ON
ON
Advertisement
Table of Contents
