Executing A Macro By Macro Attachment - Sony MVS-8000X User Manual

Knob
1

Executing a Macro by Macro Attachment

Notes
For execution on any of the M/E and PGM/PST banks, use the [MCRO
ATTCH ENBL] button in the cross-point control block. To execute a macro
according to a macro attachment set elsewhere, assign "MCRO ATTCH
ENBL" to a utility/shotbox control block or user preference button, then use
that button.
Executing a macro assigned to a button
1
2
Notes
• It is not possible to execute more than one macro at a time. Therefore, even
if you simultaneously press multiple buttons for which macro attachments
are set, only one macro is executed.
• If a button is pressed twice during macro execution or when the macro is
stopped, or if another macro is recalled, the following operation (stop or
continue) depends on a setting in setup.
For details of the settings, see "Setting the Macro Execution Mode" in
Chapter 19 (Volume 3).
958
Macro Attachment Assigning
Parameter Adjustment
No Macro attachment settings scrolling
Depending on the location of the button you want to use, press the [MCRO
ATTCH ENBL] button, turning it on.
Press the desired button for which a macro attachment has been set.
This recalls the macro register assigned to the button, and the macro is
executed as follows, according to the operation mode.
Pre macro mode: The macro is executed first, and then the button
function is executed.
Post macro mode: The button function is executed first, and then the
macro is executed.
Macro only mode: The button function is not executed, and the macro
only is executed.
During macro execution, the button you pressed flashes.
Setting values
1 and upwards