Operation Settings (Operation Menu) - Sony MVS-8000X User Manual

Operation Settings (Operation Menu)

To make settings relating to panel operation, use the Panel >Operation menu.
To display the Operation menu
In the Engineering Setup menu, select VF2 'Panel' and HF6 'Operation.'
The status area shows the items that can be set and a list of the settings.
The following functions are available here.
• Button Tally: Set whether or not the system tally generation results are
reflected in the panel tally.
• Trans Rate Display: Select whether the transition rate display mode is in
frames or timecode units.
• S-Bus Name Link: Copy the S-Bus description name to the source name.
• Effect: For keyframe effects, you can make the following settings. (See
Chapter 13 "Keyframe Effects" (Volume 2).)
– Recall mode
– Automatically turning off the [EDIT ENBL] button when an effect is
recalled
– Automatic insertion of a first keyframe when an empty register is recalled
– Effect Auto Save
– Default KF Duration
– Setting whether or not to replay the first keyframe after rewinding a GPI/
P-Bus/disk recorder/VTR/Extended VTR/Macro effect
• Source/Dest Name: For the Source/Dest (source/destination) names used by
the system, select one of the following:
– Source name set by cross-point assignment or fixed bus name
– Description name set on routing switcher
– "Type + Num" name set on routing switcher
Names assigned with Xpt Assign can be replaced later with description
names.
• Name Display: Specify the number of characters for display of the names
selected in Source/Dest Name above, as two characters, four characters, or
Auto.
• Flexi Pad Mode: Carry out Flexi Pad settings. Specify the delegation
selection coupling, and display mode for the LCD buttons. You can also
make menu settings for wipe snapshots.
• Custom Button: Set the following button operation modes.
– [ALL] button for next transition selection
– [AUTO TRANS], [TAKE] or [FTB] button during auto transition
execution
– [RUN] button during keyframe execution
– [AUTO TRANS] and [CUT] button replacement
Operation Settings (Operation Menu)
1151