Enabling The Fm Data Port Of The Switcher - Sony MVS-8000X User Manual

• When making DME settings for SWR2, for the first DME, select
[DME3] in the <1st DME> group. For the second DME, select [DME4]
in the <2nd DME> group. When a second DME is not connected, turn
all buttons in the <2nd DME> group off.
When the signal format is 1080P
You can connect up to four MVE-8000A units to SWR1.
For SWR1, you can select a DME combination as follows, depending on the
number of DMEs connected.
Only one DME connected: DME1
Tow DMEs connected: DME1 and DME2
Three DMEs connected: DME1, DME2, and DME3
Four DMEs connected: DME1, DME2, DME3, and DME4
Depending on the selected DME combination, press [DME1] (first DME),
[DME2] (second DME), [DME3] (third DME), or [DME4] (fourth DME),
turning them on.
For SWR2, the signal format cannot be changed to 1080P.

Enabling the FM Data Port of the Switcher

With the FM data port enabled, frame memory data can be transferred in a short
time between the switcher and the control panels.
Notes
If multiple control panels are in use, [FM Data Port Enbl] can be turned on for
only one control panel per switcher.
1
In the System >System Config menu, press [Switcher Assign].
The Switcher Assign menu appears.
2
Using any of the following methods, select the switcher to be set.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
The selected switcher is displayed in reverse video.
If there is only one switcher on the network, make the setting only for
SWR1 (the first switcher).
3
Press [FM Data Port Enbl], turning it on.
System Settings (System Config Menu)
1047