Sony MVS-8000X User Manual page 1087

Defining the position of a matrix
Specify where in the 1024 × 1024 S-Bus space the link matrix is to be provided,
by setting the source and destination start address.
For the matrix selected in the External Bus Link menu, use the following
procedure.
1
In the Panel >Config >Link/Program Button >External Bus Link menu,
press [Link Matrix Adjust].
The Link Matrix Adjust menu appears.
The status area shows the status of the currently selected matrix, and a list
of the source and destination start addresses that can be selected.
In this menu too, you can use the knobs to select the link for the setting.
2
Using any of the following methods, define the position of the matrix to be
linked.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob
2
3
4
3
To confirm a source address selected in step 2, press [Source Set], to
confirm a destination address press [Destination Set], and to confirm a
level press [Level Set].
This confirms the selection, which is reflected in the status area.
Setting a link table
For the link selected in the External Bus Link menu, make the settings as
follows.
1
In the Panel >Config >Link/Program Button >External Bus Link >Link
Matrix Adjust menu, press [Link Table Adjust].
The Link Table Adjust menu appears.
The status area lists the status of the currently selected link, combinations
of video signals and sources, and the sources that can be selected.
2
Using any of the following methods, select the switcher cross-point button
and the matrix source to be linked to the button.
Parameter Adjustment
Source Source start address
Destination Destination start address
Level Level
Overall Control Panel Settings (Config Menu)
Setting values
1 to 897
1 to 897
1 to 8
1087