Basic Procedure For Dme Wipe Settings; Dme Wipe Settings Menu; Dme Wipe Pattern Selection - Sony MVS-8000X User Manual

Multi-format production switcher processor with ccp-8000 series center control panel volume 1

Hide thumbs Also See for MVS-8000X:

Table of Contents

Basic Procedure for DME Wipe Settings

You carry out DME wipe setting operations principally using the DME Wipe

menu for each bank.

This section describes the basic procedures for DME wipe settings, taking the

M/E-1 >DME Wipe menu as an example.

For details of independent key transition DME wipe settings, see "DME Wipe

Settings for Independent Key Transitions" (page 360).

For details of resizer DME wipe, see page 364.

Accessing the DME Wipe menu

To access the M/E-1 >DME Wipe menu, use either of the following operations.

• In the menu control block, select the top menu selection button [M/E 1], and

press VF6 'DME Wipe.'

To select [M/E-4], a previous assignment in the Setup menu is required.

• In the transition control block of the M/E-1 bank, press the transition type

selection button [DME] twice in rapid succession.

Either of the above operations displays the M/E-1 >DME Wipe menu.

Selecting a DME wipe pattern by a menu operation

In the M/E-1 >DME Wipe menu, select HF1 '1ch' for one-channel mode,

HF2 '2ch' for two-channel mode or HF3 '3ch' for three-channel mode.

Select the desired DME wipe pattern group with one of the following

• Slide/Squeeze: slide and squeeze

• Split/Door: split and door

Basic Procedure for DME Wipe Settings