Sony MVS-8000X User Manual page 1156

1156
Operation Settings (Operation Menu)
Operation mode during an auto transition: For the operation mode
when the [AUTO TRANS] or [TAKE] button is pressed once more
during an auto transition, select [Continue] or [Cancel] in the <Auto
Trans/Take> group.
Continue: Continue the auto transition.
Cancel: Cancel the auto transition and return to the state before
starting the auto transition.
Operation mode during keyframe execution: For the operation mode
when the [RUN] button is pressed once more during effect execution,
select [Continue] or [Cancel] in the <Run> group.
Continue: Continue the execution.
Cancel: Cancel the execution and return to the state before starting the
execution.
Status display for auto transition execution button: When the [AUTO
TRANS] or [TAKE] button is pressed to carry out an auto transition,
select how the button is lit or off in the <Auto Trans/Take Key On
Stats> group.
Disable: Lights amber during the transition, and goes off at the end of
the transition.
Enable: Lights green during the transition, and at the end of the
transition lights red if on air and amber if not on air.
Notes
This setting is only valid in the independent key transition execution
section of the following control block.
• Transition control block (standard)
• Downstream key control block (DSK Fader Module)
• Independent key transition control block (simple type)
• Downstream key/fade-to-black control block
Interchanging the [AUTO TRANS] and [CUT] buttons: To
interchange the [AUTO TRANS] and [CUT] buttons in the transition
control block, press the [Auto Trans/Cut Swap] button, turning it on.
Transition preview operation mode: For the operation mode of the
[TRANS PVW] button, select [Lock] or [Hold] in the <Trans Pvw>
group. The setting as to whether to use the "One-time mode" in which
the transition preview terminates when the transition completes, or to
use button control, is made on the switcher side (see page 1189).
[KEY] button operation mode for key source bus operations: When the
key source bus is selected with the delegation buttons in the auxiliary
bus control block, specify the [KEY] button operation mode in the
<Key Source Bus Select Mode> group, as follows.
Key: If you select this, the [KEY] button is always lit, and this mode
allows only key signals to be selected with the cross-point buttons.
Video & Key: The [KEY] button is enabled, and either video or key
signals can be selected.