Sony MVS-8000X User Manual page 286

Multi-format production switcher processor with ccp-8000 series center control panel volume 1

Hide thumbs Also See for MVS-8000X:

Table of Contents

Key snapshot operation on the Multifunction Flexi Pad control

By default, the [KEY SS] key snapshot mode selection button does not appear

in the Multifunction Flexi Pad control block. To carry out key snapshot saving

and recall in this control block, it is first necessary in the Engineering Setup

>Panel >Config >Link/Program Button >Multi Function >Mode Sel Assign

menu to assign the Key Snapshot mode to a mode selection button.

To save a key snapshot

For example, to save a key snapshot for key 1 of M/E-1, select M/E1 and key1,

then use the following procedure.

Key Snapshots

If both buttons are off, the key memory function is enabled and only the

saved selection of key fill and key source signals is recalled.

Press the key source name display/key snapshot button corresponding to

the register you want to recall.

The button you pressed lights yellow, and this recalls the key snapshot.

To cancel a recall carried out in the downstream key control block, press

the [UNDO] button in the downstream key control block.

Press the [K SS] button.

The button displays in the memory recall section change as shown in the

following illustration.

In the memory recall section, hold down the [STOR] button, and press the

button (any of [1] to [4]) for the register in which you want to save the key