Sony MVS-8000X User Manual page 488

Multi-format production switcher processor with ccp-8000 series center control panel volume 1

Hide thumbs Also See for MVS-8000X:

Table of Contents

The following describes an example using M/E-1, but the operation is the same

for other banks.

• This setting is linked to the setting in the Engineering Setup >Switcher >

Config >PGM Config menu.

• It is not possible to make this setting while the above PGM Config menu is

locked, or [Recall M/E Config] (see previous item) is set to Off.

Keys recalled in a snapshot recall

If a snapshot is recalled independently on main or sub, this only retrieves the

settings for the key assigned to the recalled side. For example, if key 1 and key

2 are assigned on main, and key 3 and key 4 are assigned on sub, then if you

recall a snapshot on main, this only retrieves the settings for key 1 and key 2,

and the state of key 3 and key 4 assigned on sub is not affected.

Assigning sub preview output to preview selection buttons

You can assign the sub preview output to a preview selection button in the

fade-to-black control block or downstream key/fade-to-black control block.

For details, see "Overall Control Panel Settings (Config Menu)" in Chapter

19 (Volume 3).

When the Multi Program 2 license is valid, by assigning the "Shift" function to

a button, you can assign two preview outputs, "Shift" and "Unshift" to a single

button. To use the shift output, always assign "Shift" to some button.

Changing the matrix size to Standard

When using a router, if the matrix size is set to [128×128], it is not possible to

control the utility 3 bus on the S-Bus. When using Multi Program 2, in the

<Matrix Size> group of the Engineering Setup >Router/Tally >Router menu,

select other than [128×128].

For details, see "Assigning Switcher Inputs and Outputs to S-Bus Space" in

Chapter 23 (Volume 3).

When [136 × 138] is selected, as for the bus number of the utility 3 bus, a DME

Key bus number is used as follows.

Multi Program 2

In the M/E-1 menu, select first VF7 'Misc,' then HF5 'Key Assign.'

The Key Assign menu appears, and the current key assignment is shown

in the status area.

Change the setting in "Key Enable" as required.