Sony MVS-8000X User Manual page 678

Multi-format production switcher processor with ccp-8000 series center control panel volume 1
Hide thumbs Also See for MVS-8000X:
Table of Contents

Advertisement

3
4
Switching the priority between the current image and trail
superimposed
In the <Priority> group, select the method of superimposition.
Over: Current image is on top.
Under: Trail is on top.
Selecting the source to create a trail
In the <Trail Source> group, select the source to create a trail.
Notes
• "Rainbow," "Mix Color," and "Ext Video" are not supported on the MVE-
8000A.
• "Mix Color" or "Ext Video" can only be applied to one of the background
(see page 705), flex shadow (see page 608), trail, and wind (see page 685)
effects.
If you select "Mix Color" or "Ext Video" in one of these settings, a selection
of "Mix Color" or "Ext Video" in any of the other effects is disabled, and
"Flat Color" is selected in its place.
• When executing combining four channels of DME images, "Mix Color" and
"Ext Video" in the flex shadow and background effects cannot be selected.
Freeze Video: Use freeze images of the input video as source of the trail.
Flat Color: Use a flat color matte as source of the trail. You can set the
678
DME Special Effect Operations
The Trail effect is enabled. You can adjust the parameters with the knobs.
Set the parameters.
Knob
Parameter
1
Decay
2
Interval
3
Live
a) 0.00 is no trail. At 100.00, the trail does not disappear.
To erase the trail, press [Trail Eraser], turning it on.
following parameters with the knobs.
Knob
Parameter
1
Luminance
2
Saturation
Adjustment
Degree to which the trail is left
Freeze interval
Proportion of the interval
between two successive freeze
images for which the video is
run
Adjustment
Luminance
Saturation
Setting values
a)
0.00 to 100.00
1 to 255 (frames)
0.00 to 100.00
Setting values
0.00 to 100.00
0.00 to 100.00

Advertisement

Table of Contents
loading

Table of Contents