Recalling A Macro Register And Executing A Macro - Sony MVS-8000X User Manual

Recalling a Macro Register and Executing a Macro

Executing a macro in normal execution mode
1
In the simple type Flexi Pad control block, press the [MCRO] button,
turning it on.
This assigns the Flexi Pad control block to macro operation.
The numeric display shows the number of the last recalled register.
The buttons of the memory recall section show the selected register status.
Lit orange: register holding macro data
Lit yellow: last recalled register
Off: empty register
2
Press the button in the memory recall section showing the register to be
recalled.
The button you pressed lights yellow, the macro register is recalled, and
the macro is executed.
During the macro execution, the button pressed remains yellow, but
flashes, and when the macro execution completes it changes to
permanently lit.
The numeric display shows the selected register number.
Notes
• Only one macro can be executed at a time.
• If the same register is recalled again during macro execution or when the
macro is paused, the following operation depends on a setting in setup.
For details of the settings, see "Setting the Macro Execution Mode" in
Chapter 19 (Volume 3).
• Individual events registered in a macro are executed according to the
setup settings. If you change the setup settings, the content of the macro
may not be played back.
• During macro execution, if you switch the control panel to macro editing
mode, the macro currently being executed stops.
• It is not possible to execute a macro during macro editing.
Executing a macro in normal execution mode (with pause events
set)
When the macro execution is paused, the [Take] button is assigned to the
simple type Flexi Pad memory recall section.
Macro Operations in the Simple Type Flexi Pad Control Block
929