Sony MVS-8000X User Manual page 959

• Individual events stored in a macro are executed according to the settings in
setup. If you change the settings in setup, a saved macro may not have the
expected effect.
• During macro execution, if you switch the control panel to macro editing
mode, the macro being executed stops.
• During macro editing, pressing a button for which a macro attachment is set
does not execute the macro.
To disable macro attachment settings
Depending on the location of the button you want to disable, press the [MCRO
ATTCH ENBL] button, turning it off.
In this state, pressing a button for which a macro attachment is set does not
execute the macro.
Executing a macro assigned to a fader lever
1
In the cross-point control block for the fader lever on which you want to
execute the macro, press the [MCRO ATTCH ENBL] button, turning it on.
2
Move the fader lever from the start position to the end position.
When the fader lever passes the position at which the macro attachment is
set, the macro register is recalled, and the macro is executed.
Notes
• Unless you move the fader lever to the end position (completing the travel),
it is not possible to execute the macro again.
• When the preset color mix stroke mode is Normal (see "Settings Relating to
Video Switching (Transition Menu)" in Chapter 20 (Volume 3)), the first
lever operation executes the macro, but the second lever operation does not.
• If a button is pressed twice during macro execution or when the macro is
stopped, or if another macro is recalled, the following operation (stop or
continue) depends on a setting in setup.
For details of the settings, see "Setting the Macro Execution Mode" in
Chapter 19 (Volume 3).
• Individual events stored in a macro are executed according to the settings in
setup. If you change the settings in setup, a saved macro may not have the
expected effect.
• During macro execution, if you switch the control panel to macro editing
mode, the macro being executed stops.
• During macro editing, even if you operate a fader lever with a macro
attachment set, the macro is not executed.
Macro Attachment Assigning
959