Sony MVS-8000X User Manual page 1100

• Key1, 2
• Key3, 4
• Key5, 6
• Key7, 8
• N/A (no assignment)
To assign a key to the main base
To assign a key to the independent key transition control block (simple type),
use the following procedure. Here the example shown is the case in which keys
3 and 4 ("Key3,4") are assigned to the second row switcher bank of the main
base.
1
2
3
4
To return the key assignment to the default
In the Compact Key Module Assign menu, press [Default].
This returns all key assignments for the main base to their factory default state.
To assign a key to an extension
Press [Extension Port], to display the Extension Port menu, then continue as for
the main base.
To return the extension assignments to their original values, press [Default].
1100
Overall Control Panel Settings (Config Menu)
1)
1)
1)
1)
1) These keys are the keys of the M/E-1, M/E-2, M/E-3, M/E-4 or PGM/PST bank depending
on the settings of the M/E Assign menu of the interface port for the extension section in which
the independent key transition control block is installed.
In the Panel >Config menu, press [Compact Key Module Assign].
The Compact Key Module Assign menu appears.
The left side of the status area shows data for the main base (physical
layout and switcher bank names and key assignment).
Press directly on the display on the left, to select the control block for the
assignment.
Here, press on the intersection of the "2nd Row" column and "Module"
row.
Select the key from the table on the right.
Press [Set].