Sony MVS-8000X User Manual page 356

2
3
4
Adjusting the DME wipe pattern cropping
Notes
When pattern numbers 1701 and 1702 are selected, crop cannot be used.
1
2
3
4
356
Basic Procedure for DME Wipe Settings
The Modify menu appears.
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time.
Press [Size], turning it on.
Set the following parameters.
Knob Parameter Adjustment
1 Size Set size of effect
a) The effect size when [Size] is off is taken as 100.00%.
Display indications when multiple channels are selected at the same
time
The indications on the knobs show the settings of the lowest-numbered
channel. When you turn the knobs to adjust the settings, this changes the
settings on the other channels by the same amount.
In the M/E-1 >DME Wipe menu, select HF5 'Modify.'
The Modify menu appears.
Depending on whether the selected pattern is in one-channel mode or two-
channel mode, proceed as follows.
For a pattern in one-channel mode: press [1st Ch], turning it on.
For a pattern in two-channel mode: from the <Ch Select> group, select
the corresponding channel. You can select more than one channel at
the same time. Some patterns need no selection which is fixed in the
<Ch Select> group.
In the <Crop Mode> group, press [Crop], turning it on.
Set the following parameters.
Setting values
a)
0.00 to 200.00