Master Timelines; Sequence Of Keyframe Operations - Sony MVS-8000X User Manual

Multi-format production switcher processor with ccp-8000 series center control panel volume 1

Hide thumbs Also See for MVS-8000X:

Table of Contents

pause set on a keyframe, the execution range is up to that point. Pressing the

[RUN] button again resumes the effect, which then runs to the next pause point

or the end of the effect.

Run mode setting

You can select from the following run modes for when the effect is executed.

DIRECTION: Specify the effect execution direction.

STOP NEXT KF: Run the effect, and stop at the next keyframe.

EFFECT LOOP: Repeat the effect in an endless loop.

Make these settings in the keyframe control block. (See "Run mode setting"

(page 782).)

Master Timelines

You can save the regions selected for a keyframe effect and the register

numbers saved in the regions in a master timeline register so that operation can

be applied to two or more regions at a time.

To save master timeline registers, use the numeric keypad control block or

menu; to recall them you can use the numeric keypad control block, menu, the

Flexi Pad control block or the Multifunction Flexi Pad control block.

For more details, see "Creating and Saving a Master Timeline" (page 830).

The following table shows the principal operations involved in the sequence

from creating keyframes to executing an effect. For details of each operation,

see the page number in parenthesis.

For the overview of keyframes, see "Keyframes" in Chapter 1 (Volume 1).

Recalling a register (see page 788)

To create a new effect, recall an empty register; to edit an effect, open the

Specifying the region and edit points (see page 797)

Select the region in which editing applies, and set the edit points.