Resizer Interpolation Settings - Sony MVS-8000X User Manual

Multi-format production switcher processor with ccp-8000 series center control panel volume 1

Hide thumbs Also See for MVS-8000X:

Table of Contents

Entering parameters

This operation is the same as DME three-dimensional parameter input.

For details, see "Entering Three-Dimensional Parameter Values" in Chapter

11 (Volume 2).

Resetting parameters

This operation is the same as DME three-dimensional parameter resetting.

For details, see "Entering Three-Dimensional Parameter Values" in Chapter

11 (Volume 2).

Clearing resizer effects

To clear two-dimensional transform parameters only and set the

initial state

In the device control block, press the [CLR WORK BUFR] button in the

operation buttons.

To clear all resizer parameters, and set the initial state

In the device control block, press the [CLR WORK BUFR] button in the

operation buttons, twice in rapid succession.

For the initial state, you can select either the factory default settings or user

For details of how to make this selection, see "Selecting the State After

Powering On (Start Up Menu)" in Chapter 18 (Volume 3).

Resizer Interpolation Settings

For example, to make the interpolation settings for key 1 of the M/E-1 bank,

use the following procedure.

• To shrink, magnify, or move the key, turn on the [LOC XYZ(LOC)].

Hold these buttons down while carrying out the operation of step 5 to

enable fine adjustment (fine mode).

Use the trackball and joystick for the operation.

For details of parameters, see step 3 of "Key control block operations for

key shrinking, magnification and movement" (page 272).