System Settings (System Config Menu)
To make the system settings, use the System >System Config menu.
Specify the hierarchical relationship of the devices.
To display the System Config menu
In the Engineering Setup menu, select VF1 'System' and HF2 'System
Config.'
Notes
After changing the following settings, be sure to press [Execute] to save the
new values. If you want to cancel the setting changes without saving them,
press [Clear].
Device hierarchical relationship setting
• Panel Assign: Specify the switcher controlled by a control panel.
• Switcher Assign: Specify the DME connected to a switcher.
Specifying the Switcher Controlled by the Control Panel
The number of control panels that can be connected to a single switcher
depends on the signal format setting.
1080P: 2
Other than 1080P: 4
1
In the System >System Config menu, press the [Panel Assign] button.
The Panel Assign menu appears.
2
Select the switcher to be controlled by the selected control panel, as
follows.
In the <1st Switcher> group, set either [SWR1] or [SWR2] to On to select
the switcher to be operated.
In the <2nd Switcher> group, set both [SWR1] and [SWR2] to Off.
3
To set the selected control panel as tally control master panel, press [Tally
Master], turning it on.
If there are multiple panels and processors, the control panel for which
[Tally Master] is set to On carries out tally control for the whole system.
System Settings (System Config Menu)
1045