Setting Transition Control Block Button Assignments - Sony MVS-8000X User Manual

To return the region assignment to the factory default state
In the Panel >Config >10 Key Region Assign menu, press [Default].
This returns the assignment of region selection buttons in the numeric keypad
control block to the factory default state.
To delete a region assignment
In step 3 of the procedure "Assigning a Region to the Region Selection Buttons
in the Numeric Keypad Control Block or Multifunction Flexi Pad Control
Block" (page 1091), make the selection to which the operation applies, then
press [Clear].
This clears the assignment of the selected region.
Setting the region selection buttons selected when the [ALL]
button is pressed
1
In the Panel >Config >10 Key Region Assign menu, press [All Select] in
the button area, or the [All Select] button indication in the status area,
setting it to On.
The [All Select] button indication in the status area changes to orange, and
the system switches to a mode for assigning region selection buttons to the
[ALL] button. In the factory default state, all buttons appear in reverse
video, and are assigned to the [ALL] button.
2
If you do not want to assign any region selection button to the [ALL]
button, press the corresponding button indication, setting it to Off.
The button you pressed returns to normal display.
Notes
Assignment to the [ALL] button is region by region. Changing the assignment
of a region selection button does not change the regions assigned to the [ALL]
button.

Setting Transition Control Block Button Assignments

There are three separate menus for these settings, for the left part of the
transition control block (Transition Module1), upper right part (Transition
Module2), and lower right part (Transition Module3).
The following example describes the operation for the left part (Transition
Module1 menu), but operations in the Transition Module2 and Transition
Module3 menus are similar.
Overall Control Panel Settings (Config Menu)
1093