Wipe Settings For Independent Key Transitions; Basic Procedure For Independent Key Transition Wipe Settings - Sony MVS-8000X User Manual

Multi-format production switcher processor with ccp-8000 series center control panel volume 1

Hide thumbs Also See for MVS-8000X:

Table of Contents

Wipe Settings for Independent Key

You carry out independent key transition wipe setting operations using the

Wipe Adjust menu for each keyer.

For an overview of independent key transitions, see "What is an independent

key transition?" (page 191).

This section describes the independent key transition wipe settings, taking the

M/E-1 >Key1 >Transition >Wipe Adjust menu as an example.

Basic Procedure for Independent Key Transition Wipe

Accessing the independent key transition wipe settings menu

As an example, to access the M/E-1 >Key1 >Transition >Wipe Adjust menu,

carry out the following operations.

• In the menu control block, select the top menu selection button [M/E 1] and

select VF1 'Key1' and HF6 'Transition' to display the Transition menu for

key 1, then press [Wipe Adjust].

If VF1 [Key5] is shown, press the switching button at the top of the menu, so

that [Key1-4] appears, and press VF1 [Key1].

To select [M/E-4], a previous assignment in the Setup menu is required.

• In the independent key transition control block of the M/E-1 bank, press the

key delegation button [KEY1], then press the independent key transition type

selection button [WIPE] twice in rapid succession.

Carrying out the above operation displays the M/E-1 >Key1 >Transition

>Wipe Adjust menu (which will be referred to below as simply the Key1 Wipe

Adjust menu).

Selecting the independent key transition wipe pattern

You select the independent key wipe pattern from the list of patterns displayed

in the menu.

Wipe Settings for Independent Key Transitions