Setting The Control Mode For P-Bus Devices - Sony MVS-8000X User Manual

• Action list when the trigger type is "Status"
b) When knob 2 selection is "Key Snapshot"
7
Press [Action Set] to confirm the action selection.
The selected setting appears in the status area.
Test firing the trigger
To test fire the trigger, press [Test Fire].
This outputs a trigger from the selected output port. This is not output when the
trigger type is "Status."

Setting the Control Mode for P-Bus Devices

In the <P-Bus Control> group of the Panel >Device Interface menu, select the
mode.
Trigger: When a predetermined button is pressed, the action command
assigned to that button is output, to control an external device.
Timeline: The external device is controlled as a keyframe effect controlled by
the center control panel.
Setting the SCU Editor Panel Port
When an editing keyboard is used, this port setting is for the editing keyboard
if the license for the BZS-8050 is valid (see page 1062), and for the serial tally
if the license for the BZS-8050 is invalid.
If you want to use the port setting for the serial tally when the license for the
BZS-8050 is valid, select [Serial Tally] from the <Editor Port Assign> group
in the Panel >Device Interface menu.
Serial Tally: Use the SCU editor panel port for the serial tally.
Editor Keyboard: Use the SCU editor panel port for the editing keyboard.
(In M/E-x, the x is the M/E bank number (1 to 4); in DSKx the x is the DSK number
(1 to 8); in Keyx the x is the key number (1 to 8)).
When Source is M/E-x: Keyx SS ? Recall, Keyx On, No Action
When Source is P/P: DSKx SS ? Recall, DSKx On, No Action
When Source is Common: Error Make, Error Break, Keep Break, Keep Make,
PREFS1, PREFS2, PREFS3, PREFS4, PREFS5, PREFS6, PREFS7, PREFS8,
PREFS9, PREFS10, PREFS11, PREFS12, PREFS13, PREFS14, PREFS15,
PREFS16, Device Recording, No Action
Interfacing With External Devices (Device Interface Menu)
1147