Mode Signals - Siemens SINUMERIK 808D Parameter Manual

Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
corresponding to ...
Note for the reader
DB2700
DBX3.6
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Note for the reader
5.6

Mode signals

DB3000
DBX0.0
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Signal irrelevant for ...
corresponding to ...
Note for the reader
DB3000
DBX0.1
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Signal irrelevant for ...
corresponding to ...
Note for the reader
Parameter Manual
List Manual, 01/2017
At least one NCK alarm is present.
This is a group signal for the interface signals of all available channels:
DB3300 DBX4.6 (channel-specific NCK alarm pending).
No NCK alarm is active.
DB3300 DBX4.6 (channel-specific NCK alarm pending)
DB3300 DBX4.7 (NCK alarm with processing stop active)
Function Manual Basic Functions G2
NCK alarm is active
Signal(s) from NC (NCK → PLC)
Signal(s) updated: Cyclic
The temperature monitoring has identified an ambient temperature that is too
high (approx. 60 ). Alarm 2110 "NCK temperature alarm" is output.
The temperature monitoring has not responded.
Function Manual Basic Functions G2
AUTOMATIC mode
Signal(s) to NCK (PLC → NCK)
Signal(s) updated: Cyclic
AUTOMATIC mode is selected by the PLC program.
AUTOMATIC mode is not selected by the PLC program.
if signal "Mode change disable"
IS "active AUTOMATIC mode"
Function Manual Basic Functions K1
MDI mode
Signal(s) to NCK (PLC → NCK)
Signal(s) updated: Cyclic
MDI mode is selected by the PLC program.
MDI mode is not selected by the PLC program.
if signal "Mode change disable"
IS "active MDI mode"
Function Manual Basic Functions K1
Detailed descriptions of interface signals
5.6 Mode signals
391