Siemens SINUMERIK 808D Parameter Manual page 370

NC setting data
MD 10710 $MN_PROG_SD_RESET_SAVE_TAB can be be set so that the value written by the part
program is transferred to the active file system on reset (that is the value is
retained after reset.)
Related to ....
43760 OSCILL_END_POS
mm, degrees End position of the reciprocating axis
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Position the oscillating axis travels to after ending the sparking-out strokes.
Note:
MD 10710 $MN_PROG_SD_RESET_SAVE_TAB can be be set so that the value written by the part
program is transferred to the active file system on reset (that is the value is
retained after reset.)
Application example(s)
NC language:
Related to ....
43770 OSCILL_CTRL_MASK
- Oscillation sequence control mask
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Bit mask:
Bit no.
------------------------------------------------------------------------------
0(LSB)-1
switched off
------------------------------------------------------------------------------
370
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
0.0
0.0
0.0
0.0
0.0
0.0
OSE[Axis]=Position
MD10709 $MN_PROG_SD_POWERON_INIT_TAB
MD10710 $MN_PROG_SD_RESET_SAVE_TAB
0
0
0
0
0
0
| Meaning in OSCILL_CTRL_MASK
| 0: Stop at the next reversal point if the
| oscillating movement is switched off
|
| 1: Stop at reversal point 1 if the
| oscillating movement is switched off
| 2: Stop at reversal point 2 if the
| oscillating movement is switched off
| 3: Do not approach a reversal point when the oscillating movement is
| if no sparking-out strokes are programmed
-
DOUBLE
- -
- -
- -
- -
- -
- -
-
DWORD
0 0x7FFFFFFF
0 0x7FFFFFFF
0 0x7FFFFFFF
0 0x7FFFFFFF
0 0x7FFFFFFF
0 0x7FFFFFFF
P5
Immediately
7/7 U
7/7 U
0/0 S
0/0 S
7/7 U
7/7 U
P5
Immediately
7/7 U
7/7 U
0/0 S
0/0 S
7/7 U
7/7 U
Parameter Manual
List Manual, 01/2017