Siemens SINUMERIK 808D Parameter Manual page 188

Machine data
3.3 Channel-specific machine data
22621 ENABLE_START_MODE_MASK_PRT
- Enables MD22620 $MC_START_MODE_MASK_PRT
-
- -
Description:
MD22620 $MC_START_MODE_MASK_PRT is activated via MD22621
$MC_ENABLE_START_MODE_MASK_PRT.
If MD22621 $MC_ENABLE_START_MODE_MASK_PRT is in its initial setting, MD22620
$MC_START_MODE_MASK_PRT is inactive.
Bit0 =
If a "search via program test" (English abbr. SERUPRO) is started from RESET (PI
service _N_FINDBL mode paramter == 5), MD22620 $MC_START_MODE_MASK_PRT replaces
MD20112 $MC_START_MODE_MASK.
This method can be used to set a start behavior differing from PLC start when the
search is started.
22700 TRACE_STARTTRACE_EVENT
- Diagnostic data rec. starts with event
TRACE_STARTTRACE_EVENT.
NBUP
- -
Description:
The machine data is intended for diagnostics.
The recording of the diagnostic data does not start until the event
(TRACE_STARTTRACE_EVENT) has occurred at the trace point
(TRACE_STARTTRACE_TRACEPOINT) and in the correct step (TRACE_STARTTRACE_STEP)!
The machine data is additionally activated using the Cancel alarm key.
22702 TRACE_STARTTRACE_STEP
- Conditions for start of trace recording
NBUP
- 2
Description:
The machine data is only intended for diagnostic use.
See TRACE_STARTTRACE_EVENT
For TRACE_STARTTRACE_EVENT BLOCK_CHANGE the string TRACE_STARTTRACE_STEP is
interpreted as a file name and block number!
For BSEVENTTYPE_SETALARM the string is interpreted as an alarm number.
The machine data can be additionally activated using the Cancel alarm key.
22704 TRACE_STOPTRACE_EVENT
- Conditions for stop of trace recording
NBUP
- -
Description:
The machine data is only intended for diagnostics.
The recording of the diagnostic data ends when the event (TRACE_STOPTRACE_EVENT) has
occurred at the trace point (TRACE_STOPTRACE_TRACEPOINT) and in the correct step
(TRACE_STOPTRACE_STEP)!
188
0x0, 0x0, 0x0, 0x0,
0x0, 0x0, 0x0, 0x0...
1:
-
,, , , , , , , , , , , , , , ...
CLEARCANCELALAR
M_M,
CLEARCANCELALAR
M_M,
CLEARCANCELALAR
M_M, CLEA...
EXP, C03
DWORD
0 0x1
EXP, C06
STRING
- -
EXP, C06
STRING
- -
EXP, C06
STRING
- -
M3, K1
Reset
1/1 M
-
PowerOn
1/1 M
-
PowerOn
1/1 M
-
PowerOn
1/1 M
Parameter Manual
List Manual, 01/2017