Siemens SINUMERIK 808D Parameter Manual page 379

Hide thumbs Also See for SINUMERIK 808D:
Table of Contents

Advertisement

DB1700
DBX7.1
Edge evaluation: Yes
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Note for the reader
DB1700
DBX7.3
Edge evaluation: No
Signal state 1
Signal state 0
corresponding to ...
Note for the reader
DB1700
DBX7.7
Edge evaluation: No
Signal state 1
Signal state 0
Parameter Manual
List Manual, 01/2017
NC start
Signal(s) to PLC (HMI → PLC)
Signal(s) updated: Cyclic
AUTOMATIC mode:
The selected NC program is started or continued, or the auxiliary functions
that were saved during the program interruption are output.
If data is transferred from the PLC to the NC during program status "Program
interrupted," then this data is immediately processed with NC start.
MDI mode:
The entered block information or part program blocks are released for exe‐
cution.
No effect.
Function Manual Basic Functions K1
NC stop
Signal(s) to PLC (HMI → PLC)
Signal(s) updated: Cyclic
AUTOMATIC or MDI mode:
Execution of the active part program in the channel is stopped. The axes
(not spindles) are braked to a standstill maintaining the parameterized ac‐
celeration rates.
● Program status: Stopped
● Channel status: Interrupted
JOG mode:
In the JOG mode, incompletely traversed incremental paths (INC...) are
executed at the next NC start.
Note:
If data is transferred to the NCK after NC stop (e.g. tool offset), then this
data is processed with the next NC start.
No effect.
DB3300 DBX3.2 (program status stopped)
DB3300 DBX3.6 (channel status interrupted)
Function Manual Basic Functions K1
Reset
Signal(s) to PLC (HMI → PLC)
Signal(s) updated: Cyclic
The channel is reset. The initial settings are made (e.g. for G functions).
The channel alarms are deleted if they are not POWER ON alarms. The
"Reset" signal must be issued by the PLC (e.g. using a logic operation with
the reset key on the MCP). The signal is only evaluated by the selected
channel.
The program status changes to "Interrupted".
No effect.
Detailed descriptions of interface signals
5.3 Signals from / to HMI
379

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik808d advanced

Table of Contents