Siemens SINUMERIK 808D Parameter Manual page 405

Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
corresponding to ...
Note for the reader
DB3200
DBX7.3
Edge evaluation: No
Signal state 1 or
edge change 0
→ 1
Signal state 0 or
edge change 1
→ 0
Application
Special cases,
errors, ...
corresponding
to ...
Note for the
reader
DB3200
DBX7.4
Edge evaluation: No
Parameter Manual
List Manual, 01/2017
The NC program being executed is stopped after the part program block being
executed has been completely processed. Otherwise, as for "NC stop".
No effect
IS "NC stop"
IS "NC stop axes plus spindles"
IS "Program status stopped"
IS "Channel status interrupted"
Function Manual Basic Functions K1
NC stop
Signal(s) to channel (PLC → NCK)
Signal(s) updated: Cyclic
The NC program being executed is immediately stopped, the actual block is not
completed. Only the axes are stopped without contour violation.
Distances to go are only traversed through after a new start.
The program status changes to "stopped", the channel status changes to "interrup‐
ted".
No effect
On NC start the program is continued at the point of interruption.
The signal NC stop must be active for at least one PLC cycle.
IS "NC stop at block limit"
IS "NC stop axes plus spindles"
IS "Program status stopped"
IS "Channel status interrupted"
Function Manual Basic Functions K1
NC stop axes plus spindles
Signal(s) to channel (PLC → NCK)
Signal(s) updated: Cyclic
Detailed descriptions of interface signals
5.7 Channel-specific signals
405