Siemens SINUMERIK 808D Parameter Manual page 330

NC setting data
Description:
Default value for path feedrate, This setting data is evaluated when the part program
starts taking into account the feedrate type active at this time (see MD20150
$MC_GCODE_RESET_VALUES and MD20154 $MC_EXTERN_GCODE_RESET_VALUES).
42120 APPROACH_FEED
mm/min Path feedrate in approach blocks
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Default value for path feedrate in approach blocks (after repos., block search,
SERUPRO etc).
The contents of this settting data are only used when it is non-zero.
It is evaluated like an F word programmed for G94.
42121 AX_ADJUST_FEED
mm/min Path feed in adjustment movements
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Default value for the path feed in adjustment movements of tangential axes on
activation of a tangential axis coupling during or after block search.
The content of this setting data is only used if it is not equal to zero and bit7 = 0
of MD $MN_SEARCH_RUN_MODE is set.
It is evaluated as an F-word programmed in G94.
42122 OVR_RAPID_FACTOR
% Add. rapid traverse override can be specified through operation
-
- -
330
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., 0.0
0....
0., 0., 0., 0., 0., 0., 0., -
0....
0., 0., 0., 0., 0., 0., 0., -
0....
0., 0., 0., 0., 0., 0., 0., -
0....
0., 0., 0., 0., 0., 0., 0., -
0....
0., 0., 0., 0., 0., 0., 0., -
0....
0., 0., 0., 0., 0., 0., 0., -
0....
100., 100., 100., 100., 0.0
100., 100., 100., 100....
- -
DOUBLE Immediately
- 2/2
- 2/2
- 2/2
- 2/2
- 7/7
- 7/7
- -
DOUBLE Immediately
- 2/2
- 2/2
- 2/2
- 2/2
- 7/7
- 7/7
- MD12050
$MN_OVR_FACTOR_RAPID_T
RA, $AC_OVR
DOUBLE Immediately
- 7/7
M
M
M
M
U
U
M
M
M
M
U
U
U
Parameter Manual
List Manual, 01/2017