Siemens SINUMERIK 808D Parameter Manual page 206

Machine data
3.3 Channel-specific machine data
run time is measured with the time for which the override was set to 0.
Bits 2 to 31
Reserved
27860 PROCESSTIMER_MODE
- Activation and impact of program runtime measurement
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Timers are provided as system variables under the function program runtime. While the
NCK-specific timers are always activated (for time measurements since the last control
power on), the channel-specific timers have to be started via this machine data.
Meaning:
Bit 0 = 0
No measurement of total operating time for any part program
Bit 0 = 1
Measurement of total operating time is active for all part programs
($AC_OPERATING_TIME)
Bit 1 = 0
No measurement of current program runtime
Bit 1 = 1
Measurement of current program runtime is active ($AC_CYCLE_TIME)
Bit 2 = 0
No measurement of tool operating time
Bit 2 = 1
Measurement of tool operating time is active ($AC_CUTTING_TIME)
Bit 3
Reserved
Bits 4,5 only when bit 0, 1, 2 = 1:
Bit 4 = 0
Bit 4 = 1
Bit 5 = 0
Bit 5 = 1
Bit 6 only when Bit 1 = 1:
Bit 6 = 0
Delete $AC_CYCLE_TIME also with start by ASUB and PROG_EVENTs
Bit 6 = 1
$AC_CYCLE_TIME is not deleted on start by ASUB and PROG_EVENTs.
Bit 7 only when bit 2 = 1:
Bit 7 = 0 $AC_CUTTING_TIME counts only with active tool
Bit 7 = 1 $AC_CUTTING_TIME counts irrespective of tool
206
$AC_ACT_PROG_NET_TIME is increased if override = 0; in other words, the program
0x177
0x177
0x177
0x177
0x00, 0x00, 0x00,
0x00, 0x00, 0x00,
0x00, 0x00...
0x00, 0x00, 0x00,
0x00, 0x00, 0x00,
0x00, 0x00...
No measurement with active dry run feed
Measurement also with active dry run feed
No measurement with program test
Measurement also with program test
C09
DWORD
0 0x7FF
0 0x7FF
0 0x7FF
0 0x7FF
0 0x7FF
0 0x7FF
K1
Reset
1/1 M
1/1 M
1/1 M
1/1 M
1/1 M
1/1 M
Parameter Manual
List Manual, 01/2017