Siemens SINUMERIK 808D Parameter Manual page 312

Machine data
3.4 Axis-specific machine data
37050 FIXED_STOP_ALARM_MASK
- Enable of the fixed stop alarms
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
This machine data defines whether the alarms
20091 "Fixed stop not reached",
20094 "Fixed stop canceled" and
25042 "FOC: Standstill monitoring" are output.
MD= 0
Suppression of alarm 20091 "Fixed stop not reached"
MD= 2
Suppression of alarms
20091 "Fixed stop not reached" and
20094 "Fixed stop canceled" (SW 4 and higher)
MD=3
Suppression of alarm 20094 "Fixed stop canceled" (SW 4 and higher)
Add value 8
Suppression of alarm 25042 "FOC: Standstill monitoring" (SW 7 and higher)
Add value 16
Errors occurring during travel to fixed stop can be read out from the status variable
$AA_FXS irrespective of the setting of the alarm screen.
Standard: 1 = Alarms 20091, 20094 and 25042 are triggered
37052 FIXED_STOP_ALARM_REACTION
- Reaction with fixed stop alarms
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Behavior of VDI signal "Mode group ready" in case of fixed stop alarms:
Bit value = 0: "Mode group ready" will be deleted (drives de-energized)
Bit value = 1: "Mode group ready" remains active
Bit0: Alarm 20090 Travel to fixed stop not possible
Bit1: Alarm 20091 Fixed stop not reached
Bit2: Alarm 20092 Travel to fixed stop still active
Bit3: Alarm 20093 Standstill monitoring at fixed stop has triggered
Bit4: Alarm 20094 Travel to fixed stop canceled
All other bits without meaning.
Standard: 0 = All alarms de-energize the drives
312
1
1
1
1
1
1
Trigger alarm 20095 only if the brake test torque is less than the holding torque
0
0
0
0
0
0
A05, A10
BYTE
0 31
0 31
0 31
0 31
0 31
0 31
A05, A10
BYTE
0 -
0 -
0 -
0 -
0 -
0 -
-
NEW CONF
ReadOnly M
ReadOnly M
ReadOnly M
ReadOnly M
7/2 M
7/2 M
-
PowerOn
ReadOnly M
ReadOnly M
ReadOnly M
ReadOnly M
7/1 M
7/1 M
Parameter Manual
List Manual, 01/2017