Siemens SINUMERIK 808D Parameter Manual page 170

Machine data
3.3 Channel-specific machine data
20700 REFP_NC_START_LOCK
- NC start disable without reference point
-
- -
Description:
0:
or part program blocks (MDI and overstore) is active even if one or all axes of the
channel have not yet been referenced.
To ensure that the axes nevertheless reach the correct position after NC startup, the
work (workpiece coordinate system = work) must be set to the correct value by means of
other methods (scratch method, automatic work offset determination etc.).
1:
point is mandatory (value > -1), must be referenced for NC startup to be enabled.
2:
of "referenced") is sufficient for NC startup in MDI or overstore.
20730 G0_LINEAR_MODE
- G0 interpolation mode
-
- -
Description:
This machine data defines the interpolation behavior of G0:
0:
axis (positioning axis), independently of the other axes, at the rapid traverse
velocity of the axis (MD32000 $MA_MAX_AX_VELO).
1:
20734 EXTERN_FUNCTION_MASK
- Function mask for external language
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
This machine data is used to influence functions in ISO mode.
Bit0: 0:
ISO mode T: "A" and "C" are interpreted as axes. If contour definition has been
programmed, "A" or "C" must be preceded by a comma.
"A" and "C" in the part program are always interpreted as a contour definition. An axis
"A" or "C" is not allowed.
Bit1: 0:
ISO mode T: G10 P < 100 tool geometry
Bit2: 0:
170
1, 1, 1, 1, 1, 1, 1, 1...
The NC/PLC interface signal DB3200 DBX7.1 (NC start) for starting part programs
Axes for which the axial MD34110 $MA_REFP_CYCLE_NR specifies that a reference
Advanced form of setting 1 in that the axis state "Position restored" (instead
TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
Non-linear interpolation (RTLIOF): Each path axis interpolates as an individual
Linear interpolation (RTLION): The path axes are interpolated jointly.
0x4800
0x4800
0x4800
0x4800
0, 0, 0, 0, 0, 0, 0, 0...
0, 0, 0, 0, 0, 0, 0, 0...
1:
P > 100 tool wear
1:
G10 P < 10000 tool geometry
P > 10000 tool wear
C01, C03
BYTE
0 2
C09
BOOLEAN
0 -
N12
DWORD
0 0x7FFFFFFF
0 0x7FFFFFFF
0 0x7FFFFFFF
0 0x7FFFFFFF
0 0x7FFFFFFF
0 0x7FFFFFFF
D1, R1, Z1
Reset
2/2 M
P2
PowerOn
2/2 M
-
Reset
1/1 M
1/1 M
1/1 M
1/1 M
1/1 M
1/1 M
Parameter Manual
List Manual, 01/2017