Siemens SINUMERIK 808D Parameter Manual page 395

Signal state 0 or edge
change 1 → 0
Note for the reader
DB3100
DBX0.2
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Note for the reader
DB3100
DBX0.3
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Special cases, er‐
rors, ...
Note for the reader
DB3100
DBX1.2
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Note for the reader
Parameter Manual
List Manual, 01/2017
MDI mode is not active.
Function Manual Basic Functions K1
Active JOG mode
Signal(s) from NCK (NCK → PLC)
Signal(s) updated: Cyclic
JOG mode is active.
JOG mode is not active
Function Manual Basic Functions K1
808D READY
Signal(s) from NCK (NCK → PLC)
Signal(s) updated: Cyclic
This signal is set after power on and all of the voltage have been established.
The mode group is now ready and part programs can be executed and axes
traversed.
The mode group/channel is not ready. Possible causes for this are:
● There is a critical axis or spindle alarm present
● Hardware fault
● Mode group incorrectly configured (machine data)
If the mode group ready changes to signal state "0", then
● the axis and spindle drives are braked down to standstill with the max.
braking current.
● the signals from the PLC to the NCK are brought into an inactive state
(initial setting).
An alarm that withdraws IS "808D READY" ensures that the channel is no
longer in the reset state. A reset is required to switch over to another mode.
(DB3000 DBX0.7)
Function Manual Basic Functions K1
Active machine function REF
Signal(s) from NCK (NCK → PLC)
Signal(s) updated: Cyclic
Machine function REF is active within JOG.
Machine function REF is not active.
Function Manual Basic Functions K1
Detailed descriptions of interface signals
5.6 Mode signals
395