Siemens SINUMERIK 808D Parameter Manual page 196

Machine data
3.3 Channel-specific machine data
24130 TRAFO_INCLUDES_TOOL_1
- Tool handling with active 1st transformation
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
This machine data states for each channel whether the tool is handled during the 1st
transformation or externally.
This machine data is evaluated only with specific transformations.
It is evaluated on the condition that the orientation of the tool with reference to
the Basic Coordinate System cannot be changed by the transformation. In standard
transformations, only the "inclined-axis transformation" fulfills this condition.
If this machine data is set, the Basic Coordinate System (BCS) refers to the tool
reference point even with active transformations. Otherwise, it refers to the tool tip
(Tool Center Point - TCP).
The method of operation of protection zones and working area limitations varies
correspondingly.
24200 TRAFO_TYPE_2
- Definition of the 2nd transformation in the channel
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
This MD states the second available transformation in each channel.
Same as TRAFO_TYPE_1, but for the second available transformation in the channel.
References:
/FB/, F2, "5-Axis Transformation"
24210 TRAFO_AXES_IN_2
- Axis assignment for transformation 2
-
808d-me42 4
196
TRUE, TRUE, TRUE, 0
TRUE, TRUE, TRUE,
TRUE, TRUE...
TRUE, TRUE, TRUE, 0
TRUE, TRUE, TRUE,
TRUE, TRUE...
TRUE, TRUE, TRUE, 0
TRUE, TRUE, TRUE,
TRUE, TRUE...
TRUE, TRUE, TRUE, 0
TRUE, TRUE, TRUE,
TRUE, TRUE...
TRUE, TRUE, TRUE, 0
TRUE, TRUE, TRUE,
TRUE, TRUE...
TRUE, TRUE, TRUE, 0
TRUE, TRUE, TRUE,
TRUE, TRUE...
0, 0, 0, 0, 0, 0, 0, 0... -
0, 0, 0, 0, 0, 0, 0, 0... -
0, 0, 0, 0, 0, 0, 0, 0... -
0, 0, 0, 0, 0, 0, 0, 0... -
0, 0, 0, 0, 0, 0, 0, 0... -
0, 0, 0, 0, 0, 0, 0, 0... -
0, 0, 0, 0 0
C07 -
BOOLEAN NEW CONF
- 1/1
- 1/1
- 1/1
- 1/1
- 7/7
- 7/7
C07 F2, M1
DWORD NEW CONF
- 1/1
- 1/1
- 1/1
- 1/1
- 7/7
- 7/7
C07 F2, M1
BYTE NEW CONF
20 1/1
M
M
M
M
U
U
M
M
M
M
U
U
M
Parameter Manual
List Manual, 01/2017