Siemens SINUMERIK 808D Parameter Manual page 406

Detailed descriptions of interface signals
5.7 Channel-specific signals
Signal state 1 or
edge change 0
→ 1
Signal state 0 or
edge change 1
→ 0
Signal irrele‐
vant for ...
Special cases,
errors, ...
corresponding
to ...
Note for the
reader
DB3200
DBX13.5
Edge evaluation: No
Signal state 1
Signal state 0
Note for the reader
406
The NC program being executed is immediately stopped, the actual block is not
completed. Distances-to-go are only completed after a new start. The axes and spin‐
dle are stopped. However, these are stopped in a controlled fashion.
The program status changes to stopped, the channel status changes to interrupted.
No effect
Channel status reset
Program status interrupted
All axes and spindles that were not caused to move by program or program block
(e.g. axes are moved by pressing the traverse keys on the machine control panel)
are not decelerated to zero speed with "NC stop axes plus spindles".
The program is continued at the interrupted place with NC Start.
The signal "NC stop axes plus spindles" must be pending for at least one PLC cycle.
IS "NC stop at block limit"
IS "NC stop"
IS "Program status stopped"
IS "Channel status interrupted"
Function Manual Basic Functions K1
Deactivate workpiece counter
Signal(s) to channel (PLC → NCK)
Signal(s) updated: Cyclic
The workpiece count monitoring is deactivated with activated tool monitoring.
No effect
Function Manual Basic Functions W1
Parameter Manual
List Manual, 01/2017