Siemens SINUMERIK 808D Parameter Manual page 419

Corresponding to ...
Note for the reader
DB3300
DBX5.0
DBX5.1
Edge evaluation: No
Description
Special cases,
errors, ...
Corresponding to ...
DB3300
DBX7.5
Edge evaluation: No
Description
Corresponding to ...
DB3300
DBX1000.0 and .1
DBX1004.0 and .1
DBX1008.0 and .1
Edge evaluation: No
Signal state 1
Signal status
Corresponding to ...
Note for the reader
Parameter Manual
List Manual, 01/2017
DB2700 DBX3.0 (NCK alarm present)
/DA/ Diagnostics Guide
Handwheel 1 active as contour handwheel
Handwheel 2 active as contour handwheel
Signal(s) updated: Cyclic
These signals show which handwheel is selected as contour handwheel:
Signal = 1
Signal = 0
The signal is kept beyond an NC Reset.
DB3200.DBX14.0, DBX14.1 (handwheel x active as contour handwheel)
Handwheel direction of rotation inversion active for contour handwheel
Signal(s) updated: Cyclic
This signal indicates whether the direction of rotation was inverted for the
contour handwheel:
Signal = 1
Signal = 0
DB3200.DBX14.0, DBX14.1 (handwheel x active as contour handwheel)
Handwheel active (1 to 2)
for axis 1 in the Work
for axis 2 in the Work
for axis 3 in the Work
Signal(s) from channel (NCK → PLC)
Signal(s) updated: Cyclic
These PLC interface signals are used to define whether this geometry axis
is assigned to handwheel 1/2 or is not assigned to any handwheel.
Only one handwheel can be assigned to an axis at any one time.
If several interface signals "activate handwheel" are set, then 'Handwheel
1' has a higher priority than 'Handwheel 2'.
If the assignment is active, then the geometry axis can be traversed using
the handwheel in the JOG mode.
This geometry axis is not assigned to handwheel 1/2.
IS "Activate handwheel" (DB3200 DBX1000.0/.1,
DB3200 DBX1004.0/.1, DB3200 DBX1008.0/.1)
Function Manual Basic Functions H1
Detailed descriptions of interface signals
5.7 Channel-specific signals
Handwheel x is selected as contour handwheel.
Handwheel x is deselected as contour hand‐
wheel.
The direction of rotation of the contour hand‐
wheel is inverted.
The direction of rotation of the contour hand‐
wheel is not inverted.
419