Ipo_Max_Load; Stop_Mode_Mask; Asup_Start_Mask - Siemens SINUMERIK 808D Parameter Manual

Machine data
3.2 General machine data
6
SERUPRO as command axes in the approach block.
7
level of "Repos Delay" is read if REPOSA is interpreted. Axes that are neither geo nor
orientation axes are then excluded from the REPOS, that is REPOS does NOT move these
axes. NOTICE: This bit completely switches off the channel-specific VDI Signal
ReposPathMode.
11510

IPO_MAX_LOAD

% Max. permitted IPO load
-
- -
Description:
Enable utilization analysis via synchronized actions.
This MD11510 $MN_IPO_MAX_LOAD sets the IPO computing time (in % of the IPO cycle) after
which the variable $AN_IPO_LOAD_LIMIT is to be set to TRUE. The variable is reset to
FALSE if the value falls below this after having once exceeded it.
This diagnostics function is disabled if the machine data is 0.
11550

STOP_MODE_MASK

- Defines the stop behavior.
-
- -
Description:
This MD describes the stop behavior of the NCK under certain conditions:
Bit no.
Bit 0 == 0 :=
No stop if G codes G331/G332 are active and a path motion or G4 has also been
programmed.
Bit 0 == 1 :=
A stop is possible during G331/G332 with interruption of the continuous-path mode (G60
or G4 between G331/G332 blocks interrupt the continuous-path mode).
Bits 1.....15
Not assigned
11602

ASUP_START_MASK

- Ignore stop conditions for ASUB
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
This machine data defines which stop reasons are to be ignored on an ASUB start. The
ASUB is started or the following stop reasons are ignored:
Bit 0:
STOP reason: STOP key, M0 or M01
An ASUB is started immediately if NCK is in RESET status (or JOG mode) (no ASUB can be
started in RESET/JOG without this bit).
Bit 1:
Reserved! This bit was replaced by MD20105 $MC_PROG_EVENT_IGN_REFP_LOCK and MD20115
$MC_IGNORE_REFP_LOCK_ASUP.
74
When the bit is set, neutral axes and positioning spindles are repositioned after
The bit changes the behavior of the VDI-AXIN interface signal "Repos Delay". The
0.00
0
Meaning
0x01
0x01
0x01
0x01
0
0
N01, N05
DOUBLE
0.0 100.0
N01
DWORD
0 0x1
N01
DWORD
0 0xf
0 0xf
0 0xf
0 0xf
0 0xf
0 0xf
-
PowerOn
1/1 M
V1
PowerOn
2/2 M
K1, M3, TE3, TE7
PowerOn
1/1 M
1/1 M
1/1 M
1/1 M
2/2 M
2/2 M
Parameter Manual
List Manual, 01/2017