Siemens SINUMERIK 808D Parameter Manual page 324

NC setting data
41120 JOG_REV_SET_VELO
mm/rev Revolutional feedrate of axes in JOG mode
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Description:
Value not equal to 0:
The velocity value entered applies to axes traversed in JOG mode if revolutional
feedrate (G95) is active for the relevant axis (SD41100 $SN_JOG_REV_IS_ACTIVE = 1).
The axis velocity is active for
●
continuous jogging
●
incremental jogging (INC1, ... INCvar)
●
handwheel traversing. The value entered is valid for all axes and must not exceed
the maximum permissible axis velocity (MD32000 $MA_MAX_AX_VELO).
Value = 0:
If 0 has been entered in the setting data, the active revolutional feedrate in JOG mode
is MD32050 $MA_JOG_REV_VELO "revolutional feedrate with JOG".
Each axis can be given its own revolutional feedrate with this MD (axial MD).
SD irrelevant for ......
●
For axes if SD41100 $SN_JOG_REV_IS_ACTIVE = 0
Application example(s)
The operator can define a JOG velocity for a particular application.
Related to ....
Axial SD41100 $SN_JOG_REV_IS_ACTIVE (revolutional feedrate for JOG active)
Axial MD32050 $MA_JOG_REV_VELO (revolutional feedrate with JOG)
Axial MD32000 $MA_MAX_AX_VELO (maximum axis velocity)
41130 JOG_ROT_AX_SET_VELO
rev/min Axis velocity for rotary axes in JOG mode
-
- -
Description:
Value not equal to 0:
The velocity entered applies to rotary axes in JOG mode (to continuous jogging,
incremental
rotary axes, and must not exceed the maximum permissible axis velocity (MD32000
$MA_MAX_AX_VELO).
With DRF, the velocity set with SD41130 $SN_JOG_ROT_AX_SET_VELO must be reduced by
MD32090 $MA_HANDWH_VELO_OVERLAY_FACTOR.
Value equal to 0:
If the value 0 is entered in the setting data, the velocity applied to rotary axes in
JOG mode is the axial MD32020 $MA_JOG_VELO (jog axis velocity). In this way, it is
possible to define a separate JOG velocity for each axis.
Application example(s)
The operator can define a JOG velocity for a particular application.
Related to ....
MD32020 $MA_JOG_VELO (JOG axis velocity)
MD32000 $MA_MAX_AX_VELO (maximum axis velocity)
324
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
0.0 0.0
jogging, jogging with handwheel). The value entered is common to all
- H1
DOUBLE Immediately
- 1/1
- 1/1
- 1/1
- 1/1
- 7/7
- 7/7
- H1
DOUBLE Immediately
- 7/7
M
M
M
M
U
U
U
Parameter Manual
List Manual, 01/2017