Siemens SINUMERIK 808D Parameter Manual page 263

808d-te62 1
808d-mte40 1
808d-mte60 1
Description:
Configuration of the dynamic stiffness control (DSC):
0:
(default scenario).
1:
Notes:
The availability of this function is determined by the drive used (the drive must
support the DSC function).
With SINAMICS (P1193 not equal to 0), the value of this machine data must be set to 0.
32644 STIFFNESS_DELAY_TIME
s Dynamic stiffness control: Delay
CTEQ
808d-me42 1
808d-me62 1
808d-te42 1
808d-te62 1
808d-mte40 1
808d-mte60 1
Description:
Configuration of compensation dead time of the dynamic stiffness control (DSC) with
optimized PROFIBUS/PROFINET cycle, unit: seconds
32700 ENC_COMP_ENABLE
- Encoder/spindle error compensation.
-
- 1
Description:
1: LEC (leadscrew error compensation) is activated for the measuring system.
This enables leadscrew and measuring system errors to be compensated.
The function is not enabled internally until the relevant measuring system has been
referenced (NC/PLC interface signal DB390x DBX0.4 / .5 (Referenced/synchronized 1 or
2) = 1).
write protect function (compensation values) active.
0: LEC is not active for the axis/measuring system.
Related to:
MD38000 $MA_MM_ENC_COMP_MAX_POINTS number of interpolation points with LEC
NC/PLC interface signal DB390x DBX0.4 (Referenced/synchronized 1)
NC/PLC interface signal DB390x DBX0.5 (Referenced/synchronized 2)
32710 CEC_ENABLE
- Enable of sag compensation
-
808d-me42 -
808d-me62 -
808d-te42 -
808d-te62 -
808d-mte40 -
808d-mte60 -
Parameter Manual
List Manual, 01/2017
0
0
0
DSC in drive works with indirect measuring system, i.e. motor measuring system
DSC in drive works with direct measuring system.
0.0
0.0
0.0
0.0
0.0
0.0
FALSE, FALSE
FALSE
FALSE
FALSE
FALSE
FALSE
FALSE
0 1
0 1
0 1
A01, A07
DOUBLE
-0.02 0.02
-0.02 0.02
-0.02 0.02
-0.02 0.02
-0.02 0.02
-0.02 0.02
A09
BOOLEAN
0 -
A09
BOOLEAN
0 -
0 -
0 -
0 -
0 -
0 -
Machine data
3.4 Axis-specific machine data
1/1 M
7/2 M
7/2 M
-
PowerOn
ReadOnly M
1/1 M
ReadOnly M
1/1 M
7/2 M
7/2 M
K3
NEW CONF
2/2 M
K3
NEW CONF
1/1 M
1/1 M
1/1 M
1/1 M
7/2 M
7/2 M
263