Siemens SINUMERIK 808D Parameter Manual page 172

Machine data
3.3 Channel-specific machine data
G10 is executed with internal STOPRE
Bit14: 0:
ISO mode T: No alarm if a cutting edge has been programmed in the T command.
Bit 15: 0:
ISO mode M: G51 Scale, the axial scale factors I, J, K work with 'pocket calculator
notation' as programmed.
notation', are multiplied by the value in MD22910 $MC_WEIGHTING_FACTOR_FOR_SCALE.
Bit 16: 0:
In circular-path programming with radius R, there is no replacement of missing
geometry axes of the selected plane. This corresponds to the behavior in Siemens mode
plane are supplemented by incremental distance 0
20750 ALLOW_G0_IN_G96
- G0 logic with G96, G961
-
- -
Description:
This machine data defines the speed regulation characteristic of the spindle in G0
blocks with constant cutting rate (G96, G961) selected .
1:
previous block that was unequal G0.
Prior to a subsequent block that does not contain G0, the spindle speed is increased
to a value that belongs to the transverse axis position of the subsequent block.
0:
20800 SPF_END_TO_VDI
- End of subroutine to PLC
-
- -
Description:
Bit 0 = 1:
The M functions for subroutine end (M17 and/or M2/M30) are transferred to the PLC
interface.
Bit 0 = 0:
The M functions for subroutine end (M17 and/or M2/M30) are not transferred to the PLC
interface.
Note:
To prevent stopping in continuous-path mode, M17 must not be programmed alone in a
block.
Example of a subroutine:
Bit 1 = 0:
M01:
conditional program stop is always output to PLC, irrespective of whether the M01
signal is active or not.
172
1:
1:
ISO mode T: Alarm 14185 if a cutting edge has not been programmed in the T command.
1:
ISO mode M: G51 Scale, the axial scale factors I, J, K with 'pocket calculator
1:
In circular-path programming with radius R, missing geometry axes of the selected
TRUE, TRUE, TRUE,
TRUE, TRUE, TRUE,
TRUE, TRUE...
In a G0 block, the spindle speed is kept constant at the last value of the
In a G0 block, the spindle speed changes against the transverse axis position.
1, 1, 1, 1, 1, 1, 1, 1...
C09, C05
BOOLEAN
0 -
C04, C03
BYTE
- -
G64 F2000 G91 Y10 X10
X10 Z10 M17
P2, V1
PowerOn
1/1 M
H2, K1
PowerOn
1/1 M
Parameter Manual
List Manual, 01/2017