Siemens SINUMERIK 808D Parameter Manual page 171

G04 dwell time: always [s] or [ms]
If G95 is active, in spindle revolutions
Bit3: 0:
Errors in ISO mode lead to an alarm
Errors in ISO mode are not output, the block is translated in Siemens mode.
Bit4: 0:
G00 is traversed with the current exact stop - continuous-path mode G code
G00 is always traversed with G09
Bit5: 0:
Modulo rotary axis is positioned at the shortest possible distance
Direction of rotation of modulo rotary axis depends on sign
Bit6: 0:
Only 4-digit program number allowed.
8-digit program number allowed. If the program number has less than 4 digits, it is
expanded to 4 digits with 0.
Bit7: 0:
Axis programming for geometry axis exchange/parallel axes is compatible with ISO mode.
Axis programming for geometry axis exchange/parallel axes in ISO mode is compatible
with Siemens mode.
Bit8: 0:
With cycles, the F value transferred is always interpreted as a feedrate.
With threading cycles, the F value transferred is interpreted as a pitch.
Bit9: 0:
Multiplication with 0.01mm / 0.0001inch is carried out in ISO mode T for G84, G88 and
in standard mode F for G95.
Multiplication with 0.001mm / 0.00001inch is carried out in ISO mode T for G84, G88
and in standard mode F for G95.
Bit10: 0:
With M96 Pxx, the program programmed with Pxx is always called in the case of an
interrupt
With M96 Pxx, CYCLE396.spf is always called in the case of an interrupt
Bit11: 0:
With G54 Pxx, only G54.1 is displayed
With G54 Pxx, the programmed program is displayed after the point, e.g. G54.48
Bit12: 0:
When the subroutine defined with M96 Pxx is called, $P_ISO_STACK is not modified
When the subroutine defined with M96 Pxx is called, $P_ISO_STACK is incremented
Bit13: 0:
G10 is executed without internal STOPRE
Parameter Manual
List Manual, 01/2017
1:
1:
1:
1:
1:
1:
1:
1:
1:
1:
1:
Machine data
3.3 Channel-specific machine data
171