General Selection / Status Signals To Hmi - Siemens SINUMERIK 808D Parameter Manual

Detailed descriptions of interface signals
5.3 Signals from / to HMI
corresponding to ...
Note for the reader
DB1900
DBX1003.7
DBX1004.7
Edge evaluation: No
Signal state 1
Signal state 0
corresponding to ...
Note for the reader
5.3.6

General selection / status signals to HMI

DB1900
DBX5000.2
Edge evaluation: No
Signal state 1
Signal state 0
DB1900
DBX5000.7
Edge evaluation: No
Signal state 1
Signal state 0
384
DB1900 DBX1003.0 - .2 (axis number for handwheel 1)
DB1900 DBX1004.0 - .2 (axis number for handwheel 2)
DB1900 DBX1003.7/1004.7 (machine axis for handwheel 1/2)
DB380x DBX4.0/.1 (activate handwheel 1/2)
DB390x DBX4.0/.1 (handwheel 1/2 active)
Function Manual Basic Functions H1
Machine axis
for handwheel 1
for handwheel 2
Signal(s) from NC (HMI → PLC)
Signal(s) updated: Cyclic
The operator has assigned an axis to the handwheel (1, 2) directly at the
operator panel. This axis is a machine axis – no geometry axis (axis in the
Work).
For further information see IS "Axis number".
The operator has assigned an axis to the handwheel (1, 2) directly at the
operator panel. This axis is a geometry axis (axis in the Work).
For further information see IS "Axis number".
IS "Axis number" (DB1900 DBX3.0 to .4, ff)
Function Manual Basic Functions H1
OP key lock
Signal(s) from PLC → HMI
Signal(s) updated: Cyclic
The OP keyboard is locked for the user.
The OP keyboard is enabled for the user.
Actual value in the Work
Signal(s) from PLC → HMI
Signal(s) updated: Cyclic
The PLC selects the display of actual values in the workpiece coordinate
system (Work). This means that when the machine area is selected, the
Work display is activated; i.e. the machine and the supplementary axes as
well as their actual positions and distances to go are displayed in the Work
in the "Position" window.
The interface signal is only evaluated when it enters the basic machine
screen; this means that the operator, within the machine area, can toggle
as required between the particular coordinate systems using the softkeys
"actual values Machine" and "actual values Work".
This means that when the machine area is selected the coordinate system
previously selected (Work or Machine) is reactivated and displayed.
Parameter Manual
List Manual, 01/2017